Weddingbee Blog

If you have been following along, you will remember that I selected Mr. Buttons’ wedding band from an awesome Etsy vendor: Fabuluster. But, if you don’t remember, you can refresh your memory: here! Well, now that the decision had been made, it was time to get my fingerprint molded!

The artisans at Fabuluster sent me a kit with detailed instructions on how to make my imprints. After reading the instructions about 100 times to make sure I had the process down pat, it was time to begin!

To start, I had to soak my finger in water for 10 minutes to get my fingerprint to rise (aka, my finger had to get pruny!). I sat on the couch with Mr. Buttons and watched a little TV while we did this. When the 10 minutes was up, it was time to heat some water up in the microwave to get the imprint strips started! They included 4 strips to imprint, so that if you make a mistake you had backup! I am very glad that they did this, as my first attempt at making an impression was rather pathetic. As in, I didn’t press hard enough to make a single mark in the strip! Oops.

After letting an imprint strip soak in the hot water for 30 seconds, it was time to press! The instructions said to press hard, and boy did you have to! I smashed my finger into the imprint strip and applied as much pressure as possible for the required amount of time.

I may or may not have made some faces during this process…

When the imprint was done, I ran my hand under cold water for 30 seconds, then slowly peeled the strip off of my finger… and voila! My imprint strip was complete.

I repeated this process for 4 strips, which I then sent back to Fabuluster to create Mr. Buttons’ wedding band! They will select which of the 4 strips has the best imprint to use on the ring.

Currently, his ring is in production, and I should receive it in the beginning/middle of May (I know, I’m cutting it close…). I am so excited to see the finished product!

Did you have to wait for a wedding band to be created? Was the suspense about to kill you???